Effect of friction on the perceived mode II delamination toughness from three- and four-point bend end-notched flexure tests

Clara Schuecker, Barry D Davidson

Research output: Chapter in Book/Report/Conference proceedingChapter

34 Scopus citations

Abstract

Results are presented from a study on the effect of friction on the Mode II delamination toughness as obtained by three- and four-point bend end-notched flexure tests. Finite-element analyses are used to assess the effect of friction on the compliance and energy release rate of the two types of test specimens. Energy release rates are first obtained by a virtual crack closure technique, which can be used to separate the energy lost by the system into that dissipated by friction and that used for crack advance. Energy release rates are then obtained by a simulated compliance calibration procedure. By modeling this commonly used method of data reduction and comparing results with those obtained by crack closure, the ratio of the material's intrinsic toughness to the toughness perceived by users of the tests can be assessed. For both tests, this assessment is made for physically realistic coefficients of friction and, for the four-point end-notched flexure test as a function of the ratio of inner to outer span length. It is shown that frictional effects on the perceived toughness are considerably larger in the four-point than in the three-point bend end-notched flexure geometry, but that an appropriate choice of the four-point test geometry can make the influence of friction quite small.

Original languageEnglish (US)
Title of host publicationASTM Special Technical Publication
PublisherAmerican Society for Testing and Materials
Pages334-344
Number of pages11
Edition1383
StatePublished - 2000

    Fingerprint

Keywords

  • Delamination
  • End notched flexure
  • Energy release rate
  • Friction
  • Mode II
  • Toughness

ASJC Scopus subject areas

  • Engineering(all)

Cite this

Schuecker, C., & Davidson, B. D. (2000). Effect of friction on the perceived mode II delamination toughness from three- and four-point bend end-notched flexure tests. In ASTM Special Technical Publication (1383 ed., pp. 334-344). American Society for Testing and Materials.